Author Topic: p 41 flywheel  (Read 1951 times)

0 Members and 74 Guests are viewing this topic.

Offline Bob

  • 3 cube
  • *
  • Posts: 16
  • Karma: 0

  • Total Badges: 9
    Badges: (View All)
    One year Anniversary Apple User 10 Posts Level 2 Search Topic Starter
Re: p 41 flywheel
« Reply #10 on: June 05, 2014, 07:21:10 pm »
Thanks Killian
The pictures are great I have the rings on the piston and the saw reassembled but I don't remember if  the little notch on the ring that goes against the pin is facing up as in your picture or if I have it facing down, does it matter as long as the ring is in the groove and up against the pin?
The circlips are in the groove but unlike the ones in your picture, mine were the clip ends meet stick out at a 90 degree angle it is not protruding past the piston but is close were as yours curl up.The clips came with the piston I see no way of installing them with 90 degree prongs facing into the piston.
Thank you for all your help.

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
302 Views
Last post March 26, 2012, 08:02:32 pm
by Snoopy
6 Replies
1071 Views
Last post October 14, 2012, 02:20:05 pm
by Jim372xp
3 Replies
573 Views
Last post January 17, 2013, 07:33:10 pm
by jmester
50 Replies
5141 Views
Last post March 16, 2015, 12:16:53 pm
by Cut4fun .
0 Replies
170 Views
Last post February 09, 2014, 06:15:03 pm
by 295tramp
31 Replies
1267 Views
Last post November 25, 2014, 07:12:07 am
by Al Smith
23 Replies
1949 Views
Last post November 04, 2014, 03:13:07 pm
by bloodontheice
15 Replies
1041 Views
Last post December 05, 2014, 01:30:49 pm
by aclarke
5 Replies
379 Views
Last post January 13, 2015, 08:11:11 pm
by man of stihl
6 Replies
663 Views
Last post January 02, 2016, 11:17:33 am
by Al Smith