Author Topic: p41 on/off switch coil wiring  (Read 334 times)

0 Members and 0 Guests are viewing this topic.

Offline Bob

  • 3 cube
  • *
  • Posts: 16
  • Karma: 0
Re: p41 on/off switch coil wiring
« on: March 14, 2015, 10:16:18 am »
Thank you fossil a wire is connected to the reed block mounting bolt just like you said when I installed the new coil I connected the other end of that wire to the coil mounting screw I think the end of the wire should connect to the handle like you said.
Like a dummy I did not pay attention to where the wire was attached when I took it apart I didn't see a place on the handle where it originally attached but it had to be there, hopefully someone might have a picture.
Thanks for your expertise and response.

 

Related Topics

  Subject / Started by Replies Last post
8 Replies
654 Views
Last post December 30, 2011, 08:03:29 am
by Jeff
181 wiring

Started by JP Terp « 1 2 » Husqvarna

13 Replies
528 Views
Last post May 24, 2012, 08:29:54 am
by Al Smith
4 Replies
580 Views
Last post June 07, 2012, 12:23:17 pm
by Al Smith
1 Replies
316 Views
Last post May 20, 2013, 03:57:51 pm
by Magnus
12 Replies
2047 Views
Last post March 27, 2016, 01:48:26 pm
by gregh
17 Replies
692 Views
Last post December 04, 2014, 01:12:39 pm
by Cut4fun .
3 Replies
271 Views
Last post October 11, 2016, 05:34:01 pm
by Randy
8 Replies
518 Views
Last post January 04, 2017, 05:45:03 pm
by 1manband
0 Replies
113 Views
Last post January 22, 2017, 08:33:37 am
by dannyupsolate
0 Replies
67 Views
Last post April 14, 2019, 08:41:49 am
by Cut4fun