« previous next »
Pages: [1]   Go Down

Author Topic: P41 saw Carb settings  (Read 871 times)

0 Members and 1 Guest are viewing this topic.

Offline Bob

  • 3 cube
  • *
  • Posts: 16
  • Karma: 0
P41 saw Carb settings
« on: October 13, 2014, 12:24:38 pm »
Does anyone know what the carb settings are for a Pioneer p41 saw built in the early 80s it has a tillotson carb on it.
Thank You
Logged

Share on Facebook Share on Twitter

Offline fossil

  • 6 cube
  • ****
  • Posts: 205
  • Karma: 66
  • Location: Brampton, Ontario
Re: P41 saw Carb settings
« Reply #1 on: October 13, 2014, 08:42:48 pm »
Hi Bob,

Start with one turn out on both high and low mixture screws and go from there. Mine ended up around 1-1/16 on the low and one on the high.
Logged
Tim

Offline Little Al

  • 3 cube
  • *
  • Posts: 18
  • Karma: 4
  • Location: Midi Pyrenees FRANCE
Re: P41 saw Carb settings
« Reply #2 on: October 15, 2014, 05:49:59 am »
Quote from: Bob on October 13, 2014, 12:24:38 pm
Does anyone know what the carb settings are for a Pioneer p41 saw built in the early 80s it has a tillotson carb on it.
Thank You
The paper work I have for this saw gives the default settings as Lo 1&1/8  & Hi as 7/8 turns out from lightly seated
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
0 Replies
613 Views 		Last post February 27, 2011, 12:24:14 am
by Cut4fun .
14 Replies
1581 Views 		Last post August 31, 2014, 09:48:06 am
by Cut4fun .
5 Replies
1398 Views 		Last post October 01, 2012, 06:29:08 pm
by Cut4fun .
2 Replies
512 Views 		Last post July 17, 2014, 02:55:38 pm
by circe
3 Replies
1037 Views 		Last post July 31, 2014, 01:06:25 am
by 3000 FPS
3 Replies
290 Views 		Last post December 19, 2015, 06:28:52 pm
by farmboy
5 Replies
2060 Views 		Last post February 23, 2016, 11:10:39 am
by countryhog
4 Replies
1453 Views 		Last post June 28, 2017, 04:42:13 pm
by flyingdg
5 Replies
2919 Views 		Last post April 05, 2018, 09:26:50 am
by Cut4fun .
4 Replies
779 Views 		Last post May 15, 2020, 07:11:28 am
by Cut4fun .