« previous next »
Pages: [1] 2 3 4 5   Go Down

Author Topic: Crank Bearings  (Read 2962 times)

0 Members and 26 Guests are viewing this topic.

Offline Al Smith

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2779
  • Karma: 181

    • Total Badges: 34
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 6 Seventh year Anniversary Sixth year Anniversary
Re: Crank Bearings.
« on: August 07, 2013, 09:07:20 pm »
What you will find if you really delve into it is the design of most Stihls The transistion from the crank to the output shaft is radiused rather than a square corner .As such it is a much sronger crank shaft but because of design requires also a radiused internal bearing .Of which specically Stihl owns the entire rights to from every reputable bearing manufacturer in the world .
Logged
Pages: [1] 2 3 4 5   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
12 Replies
1133 Views 		Last post August 31, 2013, 07:28:45 pm
by 660magnum
24 Replies
1580 Views 		Last post October 23, 2014, 12:22:01 pm
by Cut4fun .
2 Replies
474 Views 		Last post October 27, 2013, 09:09:17 am
by brokenbudget
18 Replies
1176 Views 		Last post November 11, 2013, 09:19:48 am
by KilliansRedLeo
Crank bearings

Started by jmester « 1 2 » Stihl

12 Replies
814 Views 		Last post July 24, 2015, 07:14:47 pm
by 67L36Driver
4 Replies
722 Views 		Last post March 10, 2016, 11:06:21 am
by 660magnum
3 Replies
787 Views 		Last post March 18, 2016, 09:02:35 am
by Jason K
6 Replies
8775 Views 		Last post April 22, 2023, 03:15:35 pm
by Cut4fun .
10 Replies
1013 Views 		Last post June 21, 2016, 03:18:11 pm
by Giles
1 Replies
411 Views 		Last post August 05, 2022, 05:02:12 am
by DNX800