Chainsaw Repair

Cut4fun invited me on and to post on the thread - Thanks!

The Tech guy I talked to on the phone who told me about LP1200 asked what I was using now.  I said well, Tygon 4040A, I was told it was the best so I bought a roll.  He said actually it’s not intended for that application (submerged in gasoline).  I said ahhh... someone should get the word out then cause that’s what all the shops and people I know are using (on old 25DAs anyway.)

So I had already ordered a roll of LP1100 from a supplier-US Plastics.  It is supposed to be ok with up to 100% ethanol.  That it is a laminate leads me to suspect that it is not supposed to sit in gas all the time either - though I did not ask the tech guy from the factory this question.  Feels a little stiff to me for following the gas around inside a 25DA tank but, I think it will work.

I’m looking forward to LP1200 and hoping it will be a one time answer.  In the mean time I trust that the LP1100 will be far better than replacing 4040A every so many months and smelling raw gas through the day as the indicator that my fuel line has shrunk and hardened.

If anyone has wanted to try LP1100 and give knowledgable input to the rest, I would send a length out to the first couple of posters/PMrs. ( 3/32 ID, 3/16 OD 3/64 Wall thickness) Length of line?  Mailing info.?