« previous next »
Pages: 1 2 [3] 4   Go Down

Author Topic: Grooving the cylinder  (Read 904 times)

0 Members and 7 Guests are viewing this topic.

Offline joe_indi

  • 5 cube
  • ***
  • Posts: 142
  • Karma: 45
  • Location: Cochin, India

    • Total Badges: 28
    Badges: (View All)
    100 Posts Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Grooving the cylinder
« Reply #20 on: March 23, 2015, 02:59:36 pm »
You are trying to tell me about the inaccuracy in using a liquid because of the surface tension which would not give an accurate level, ok I understand.

Could you tell me what happens if the squish area is increased beyond limits?
Logged
Pages: 1 2 [3] 4   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
1 Replies
286 Views 		Last post September 05, 2012, 05:23:21 pm
by Al Smith
044 Cylinder

Started by farmboy « 1 2 3 4 » Stihl

38 Replies
1843 Views 		Last post June 02, 2013, 10:02:21 pm
by HolmenTree
3 Replies
730 Views 		Last post December 21, 2013, 02:21:40 pm
by Cut4fun .
54 Replies
3144 Views 		Last post January 03, 2014, 02:14:59 pm
by Adirondackstihl
14 Replies
1186 Views 		Last post February 25, 2014, 12:38:59 pm
by jacob j.
1 Replies
398 Views 		Last post August 22, 2014, 08:33:48 pm
by 660magnum
Echo cylinder

Started by Giles « 1 2 » Echo

11 Replies
829 Views 		Last post December 04, 2014, 01:14:03 pm
by Giles
4 Replies
251 Views 		Last post February 06, 2015, 09:52:48 pm
by Jason K
4 Replies
367 Views 		Last post November 06, 2016, 10:35:55 am
by SawTroll
7 Replies
656 Views 		Last post August 25, 2017, 06:40:44 am
by jmester