Author Topic: Husqvarna 365/72 Flywheel Side Bearing  (Read 536 times)

0 Members and 0 Guests are viewing this topic.

Offline sharkey

  • Piped Saw
  • *****
  • Posts: 368
  • Karma: 37
Re: Husqvarna 365/72 Flywheel Side Bearing
« Reply #10 on: May 16, 2014, 06:26:32 am »
Great bearing info KRL.  I suppose Im one of the guys who learned to do this service wrong by putting the bearings onto the crank first.  To double check, I just re-read my cs-8000 service manual and that is how they said to do the service for that model of Echo.  Same thing in the Deere 800v service manual.  I suppose the saving grace is I always heat the cases before trying to drive anything. 

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: Husqvarna 365/72 Flywheel Side Bearing
« Reply #11 on: May 16, 2014, 08:01:40 am »
Sharkey, you are following the manufacturers procedures which is correct. The whole point of this is to show how Husqvarna recommends this be done on a 371/72 saw. There are saws in the HVA line that HVA recommends the bearings on the crank.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
1109 Views
Last post April 04, 2011, 08:26:46 pm
by hamish
6 Replies
641 Views
Last post March 17, 2012, 11:06:21 pm
by Al Smith
0 Replies
140 Views
Last post April 24, 2014, 08:13:14 am
by sharkey
6 Replies
351 Views
Last post August 27, 2014, 10:07:06 am
by weimedog
5 Replies
276 Views
Last post January 13, 2015, 08:11:11 pm
by man of stihl
8 Replies
1035 Views
Last post April 06, 2015, 06:56:20 pm
by Nathaniel Vansickle
2 Replies
235 Views
Last post April 14, 2015, 08:48:14 pm
by deereguy
5 Replies
285 Views
Last post September 18, 2015, 09:24:44 pm
by mdavlee .
1 Replies
388 Views
Last post April 19, 2017, 03:25:32 pm
by Cut4fun
4 Replies
362 Views
Last post January 28, 2020, 03:01:35 pm
by HolmenTree