Author Topic: Oil Seals from China  (Read 121 times)

0 Members and 0 Guests are viewing this topic.

Offline KilliansRedLeo

  • Nitro Hotsaw
  • *******
  • Posts: 2361
  • Karma: 80
  • Location: Rochester, NY
    • RoCHusqvarna
Re: Oil Seals from China
« on: May 21, 2014, 12:37:58 pm »
Good advice however the 365/72 saws do not use seals with an OD the same size as the OD of a 6202 bearing on either side, they are smaller than the bearing OD which is 35mm. The ID of the flywheel side is 15mm. The clutch side has to accommodate the oil pump drive sleeve which is larger than the ID of the bearing.
"When the people fear the government...you have tyranny....When the government fears the people....you have liberty"

Thomas Jefferson
1743-1826

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
447 Views
Last post April 15, 2012, 07:39:47 pm
by Old Iron Logging
5 Replies
622 Views
Last post February 09, 2014, 11:29:47 am
by Cut4fun .
8 Replies
274 Views
Last post January 22, 2014, 11:23:10 pm
by jockeydeuce
3 Replies
100 Views
Last post May 02, 2014, 11:45:00 pm
by aclarke
0 Replies
125 Views
Last post May 19, 2014, 01:28:37 am
by president
8 Replies
252 Views
Last post May 22, 2014, 08:06:07 am
by KilliansRedLeo
3 Replies
163 Views
Last post February 28, 2015, 10:00:10 am
by Cut4fun
Typical China Quality

Started by Giles « 1 2 » Stihl

14 Replies
423 Views
Last post October 24, 2015, 08:38:31 am
by mikehonda
13 Replies
636 Views
Last post January 01, 2017, 03:35:36 pm
by Cut4fun .
8 Replies
234 Views
Last post June 08, 2021, 09:59:38 am
by Cut4fun .