Author Topic: Old Gaskets  (Read 858 times)

0 Members and 24 Guests are viewing this topic.

Offline Giles

  • 6 cube
  • ****
  • Posts: 157
  • Karma: 12
  • Location: Florence Alabama

  • Total Badges: 19
    Badges: (View All)
    Fifth year Anniversary Fourth year Anniversary Third year Anniversary Level 4 100 Posts Avatar
Re: Old Gaskets
« Reply #10 on: February 05, 2015, 12:28:17 pm »
You lay the material flat on the surface first, take the  hammer and gently tap the edges. This shears the material and sometimes it's best to do the bolt holes first (use round end of hammer) and insert a bolt or pin to hold gasket in place. In many cases, you don't even need knife or scissors.   

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
641 Views
Last post January 13, 2013, 06:54:29 am
by Al Smith
1 Replies
446 Views
Last post March 06, 2013, 02:57:56 pm
by Cut4fun .
3 Replies
375 Views
Last post August 04, 2013, 07:20:00 pm
by Al Smith
5 Replies
623 Views
Last post January 16, 2014, 07:49:22 pm
by KilliansRedLeo
2 Replies
293 Views
Last post January 29, 2014, 01:10:53 pm
by KilliansRedLeo
6 Replies
484 Views
Last post November 22, 2014, 10:46:38 pm
by SteveinUT
500/5000 gaskets

Started by aclarke « 1 2 » Partner

11 Replies
1227 Views
Last post November 02, 2015, 08:02:13 am
by Cut4fun .
0 Replies
617 Views
Last post July 27, 2016, 02:49:16 pm
by bill saf