« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: Old Gaskets  (Read 884 times)

0 Members and 119 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

    • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Old Gaskets
« Reply #20 on: February 05, 2015, 08:05:28 pm »
I've had success with doing the inside of the gasket - Then putting the part together holding the gasket firmly in place- and trimming off the outside with a sharp knife.

Even the areas on the inside were cut with a sharp knife against the edge of the motor.

The screw holes just punched with the screw.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .
Pages: 1 2 [3]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
5 Replies
665 Views 		Last post January 13, 2013, 06:54:29 am
by Al Smith
1 Replies
448 Views 		Last post March 06, 2013, 02:57:56 pm
by Cut4fun .
3 Replies
379 Views 		Last post August 04, 2013, 07:20:00 pm
by Al Smith
5 Replies
634 Views 		Last post January 16, 2014, 07:49:22 pm
by KilliansRedLeo
2 Replies
299 Views 		Last post January 29, 2014, 01:10:53 pm
by KilliansRedLeo
6 Replies
492 Views 		Last post November 22, 2014, 10:46:38 pm
by SteveinUT
500/5000 gaskets

Started by aclarke « 1 2 » Partner

11 Replies
1254 Views 		Last post November 02, 2015, 08:02:13 am
by Cut4fun .
0 Replies
623 Views 		Last post July 27, 2016, 02:49:16 pm
by bill saf