Author Topic: Old Gaskets  (Read 856 times)

0 Members and 26 Guests are viewing this topic.

Offline jmester

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2106
  • Karma: 171
  • Location: MD

  • Total Badges: 36
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Level 6
Re: Old Gaskets
« Reply #20 on: February 05, 2015, 07:58:17 pm »
Have not heard of doing gaskets like that in a very long time.
FEAR NO TREE. FEAR GOD.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

  • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Old Gaskets
« Reply #21 on: February 05, 2015, 08:05:28 pm »
I've had success with doing the inside of the gasket - Then putting the part together holding the gasket firmly in place- and trimming off the outside with a sharp knife.

Even the areas on the inside were cut with a sharp knife against the edge of the motor.

The screw holes just punched with the screw.
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
641 Views
Last post January 13, 2013, 06:54:29 am
by Al Smith
1 Replies
446 Views
Last post March 06, 2013, 02:57:56 pm
by Cut4fun .
3 Replies
375 Views
Last post August 04, 2013, 07:20:00 pm
by Al Smith
5 Replies
623 Views
Last post January 16, 2014, 07:49:22 pm
by KilliansRedLeo
2 Replies
293 Views
Last post January 29, 2014, 01:10:53 pm
by KilliansRedLeo
6 Replies
484 Views
Last post November 22, 2014, 10:46:38 pm
by SteveinUT
500/5000 gaskets

Started by aclarke « 1 2 » Partner

11 Replies
1227 Views
Last post November 02, 2015, 08:02:13 am
by Cut4fun .
0 Replies
617 Views
Last post July 27, 2016, 02:49:16 pm
by bill saf