Author Topic: Step in the exhaust port  (Read 2061 times)

0 Members and 14 Guests are viewing this topic.

Offline aclarke

  • Nitro Hotsaw
  • *******
  • Posts: 1676
  • Karma: 172

  • Total Badges: 25
    Badges: (View All)
    Fourth year Anniversary Third year Anniversary 1000 Posts Second year Anniversary Level 5 500 Posts
Re: Step in the exhaust port
« Reply #10 on: May 28, 2014, 05:52:47 pm »
Or an over-run of mufflers with a larger flange!!! Lol.  I worked on a P100 that had a 1/4" grove cast into the top of the exhaust port roof/cylinder plating. It was oem, never learned the reason why Partner did this but is suspect it was to start the  blowdown event earlier while still maintaining the torque associated with low exhaust height...
Adam

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
1737 Views
Last post November 16, 2014, 01:13:35 pm
by Cut4fun .
9 Replies
1007 Views
Last post January 31, 2012, 09:28:50 pm
by Al Smith
2 Replies
427 Views
Last post March 19, 2013, 04:14:39 am
by Al Smith
20 Replies
1440 Views
Last post November 09, 2013, 10:09:18 am
by Moparmyway
3 Replies
476 Views
Last post September 25, 2014, 09:14:09 pm
by The Ripper
19 Replies
1072 Views
Last post December 24, 2015, 12:35:16 am
by weimedog
1 Replies
567 Views
Last post January 25, 2016, 11:21:00 am
by srcarr52
0 Replies
804 Views
Last post April 07, 2016, 01:41:04 pm
by Cut4fun .
4 Replies
913 Views
Last post April 18, 2018, 01:10:06 am
by 660magnum
1 Replies
379 Views
Last post January 16, 2021, 07:16:55 am
by Cut4fun .