Author Topic: Tuning carb with a tach?  (Read 184 times)

0 Members and 0 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO
Re: Tuning carb with a tach?
« Reply #10 on: February 28, 2014, 03:12:21 pm »
That is hard to do for most of us. That's why I said to have it rich enough that you are certain it is not the rev limiter.

If you hold your tach on the saw and rev the saw up and it goes into rev limiting, the tach will go nuts.
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4334
  • Karma: 189
  • OHIO REDNECK
Re: Tuning carb with a tach?
« Reply #11 on: February 28, 2014, 03:14:46 pm »
I was having a hard time telling the difference between 4 stroking and hitting the rev limiter.

If your using a tach. Here is what you will see, bouncing around rpm all over the place 11k 12k 13k  up down etc = hitting rev limiter

Fat 4 stroking  showing nice steady say 12K = 4 stroking.
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
9 Replies
967 Views
Last post March 03, 2011, 08:53:49 pm
by jamming
Tuning a saw

Started by 05_sprcrw « 1 2 3 » Husqvarna

25 Replies
1368 Views
Last post May 04, 2011, 12:45:06 pm
by 05_sprcrw
3 Replies
1416 Views
Last post August 22, 2012, 07:06:45 pm
by AussieRedGum
28 Replies
1735 Views
Last post November 09, 2013, 03:04:59 pm
by Cut4fun .
5 Replies
203 Views
Last post February 07, 2014, 06:05:21 pm
by KilliansRedLeo
1 Replies
63 Views
Last post February 07, 2014, 06:08:57 pm
by KilliansRedLeo
15 Replies
357 Views
Last post April 04, 2014, 11:17:57 pm
by Reddog
3 Replies
152 Views
Last post August 02, 2014, 06:57:23 pm
by Cut4fun .
1 Replies
242 Views
Last post December 11, 2014, 01:29:35 pm
by 660magnum
9 Replies
118 Views
Last post February 24, 2015, 07:40:26 pm
by Jason K