« previous next »
Pages: 1 [2]   Go Down

Author Topic: Tuning carb with a tach?  (Read 973 times)

0 Members and 0 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO
Re: Tuning carb with a tach?
« Reply #10 on: February 28, 2014, 03:12:21 pm »
That is hard to do for most of us. That's why I said to have it rich enough that you are certain it is not the rev limiter.

If you hold your tach on the saw and rev the saw up and it goes into rev limiting, the tach will go nuts.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4701
  • Karma: 216
  • OHIO REDNECK
Re: Tuning carb with a tach?
« Reply #11 on: February 28, 2014, 03:14:46 pm »
Quote from: eriksat1 on February 28, 2014, 03:05:23 pm
I was having a hard time telling the difference between 4 stroking and hitting the rev limiter.

If your using a tach. Here is what you will see, bouncing around rpm all over the place 11k 12k 13k  up down etc = hitting rev limiter

Fat 4 stroking  showing nice steady say 12K = 4 stroking.
Logged
Pages: 1 [2]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
9 Replies
1506 Views 		Last post March 03, 2011, 08:53:49 pm
by jamming
Tuning a saw

Started by 05_sprcrw « 1 2 3 » Husqvarna

25 Replies
2686 Views 		Last post May 04, 2011, 12:45:06 pm
by 05_sprcrw
3 Replies
2511 Views 		Last post August 22, 2012, 07:06:45 pm
by AussieRedGum
28 Replies
3360 Views 		Last post November 09, 2013, 03:04:59 pm
by Cut4fun .
5 Replies
600 Views 		Last post February 07, 2014, 06:05:21 pm
by KilliansRedLeo
1 Replies
330 Views 		Last post February 07, 2014, 06:08:57 pm
by KilliansRedLeo
7 Replies
688 Views 		Last post April 21, 2014, 09:42:26 pm
by rms61moparman
3 Replies
472 Views 		Last post August 02, 2014, 06:57:23 pm
by Cut4fun .
1 Replies
2562 Views 		Last post December 11, 2014, 01:29:35 pm
by 660magnum
9 Replies
487 Views 		Last post February 24, 2015, 07:40:26 pm
by Jason K