« previous next »
Pages: [1]   Go Down

Author Topic: 1950 wood shark not pumping oil  (Read 1039 times)

0 Members and 10 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23740
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

    • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: 1950 wood shark not pumping oil
« on: August 23, 2011, 02:38:08 pm »
I've made a habit of priming the pumps before I put one on any make of saw. Maybe I am just getting lucky.

Did you check that your worm gear was good and turning the plastic gear on pump? Did you check that the bar oiler area was clear from there to the tube going to pump? Blowing out from bar area to where the oiler mounts to tube, making sure it was clear.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
435 Views 		Last post March 16, 2014, 04:47:33 pm
by 660magnum
14 Replies
949 Views 		Last post June 08, 2014, 08:00:28 am
by jmester
0 Replies
284 Views 		Last post October 13, 2014, 12:54:59 am
by 660magnum
10 Replies
1293 Views 		Last post June 10, 2015, 10:01:59 am
by srcarr52
3 Replies
1053 Views 		Last post November 03, 2017, 09:20:30 am
by Cut4fun .
5 Replies
667 Views 		Last post November 12, 2016, 10:08:30 pm
by oldpro
7 Replies
691 Views 		Last post January 10, 2018, 07:31:01 pm
by dpjones
7 Replies
423 Views 		Last post April 05, 2018, 08:24:53 pm
by trail twister
2 Replies
270 Views 		Last post September 15, 2021, 07:50:47 am
by Cut4fun .
6 Replies
469 Views 		Last post February 14, 2022, 06:46:24 pm
by 3000 FPS