Author Topic: Poulan 3500 3600 3350  (Read 2954 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Poulan 3500
« Reply #40 on: March 14, 2015, 09:15:23 pm »
Interesting.  My PP330 was a local saw (Marin County, Ca) on CL.  Muffler halves weren't properly seated and it'd melted a wart/hole in the top cover from leaking exhaust.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
538 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1188 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
111 Replies
1292 Views
Last post September 27, 2015, 09:41:29 pm
by 3000 FPS
Poulan 3500

Started by 3000 FPS « 1 2 3 4 5 » Poulan

49 Replies
823 Views
Last post May 11, 2016, 09:21:16 pm
by 660magnum
4 Replies
148 Views
Last post November 22, 2015, 11:58:01 am
by Cut4fun .
3 Replies
236 Views
Last post November 22, 2015, 09:29:47 am
by SquareFile
2 Replies
215 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
8 Replies
210 Views
Last post December 31, 2018, 09:04:53 am
by Cut4fun .
2 Replies
142 Views
Last post January 27, 2018, 11:37:07 pm
by farmboy
3 Replies
105 Views
Last post August 07, 2018, 03:53:25 pm
by Cut4fun .