Author Topic: Poulan 361 rebuild  (Read 272 times)

0 Members and 0 Guests are viewing this topic.

Offline countryhog

  • 6 cube
  • ****
  • Posts: 176
  • Karma: 15
  • Location: NW arkansas
Re: 361 rebuild
« on: July 09, 2015, 09:00:29 am »
pulled the suspect seal last night. no dice. still tight at TDC.
wondering now if my rings are too tight. didn't measure too tight before installation; actually, I was mad I took too much off.
also wondering if its the piston. it had couple of carbon scours on it that I cleaned up. didn't measure much smaller than jug. don't remember measurements; theyre on my work bench at home.
just gonna put it together and run it and see what happens. if nothing else i'll have some extra parts.
now is never here but the past is always present.
semper fi ya'll

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
368 Views
Last post June 30, 2012, 10:04:41 am
by mgshiho
8 Replies
604 Views
Last post February 01, 2013, 03:10:13 pm
by 660magnum
2 Replies
192 Views
Last post November 08, 2013, 05:50:01 am
by sharkey
12 Replies
509 Views
Last post November 16, 2013, 06:47:39 am
by NHRA1877
6 Replies
193 Views
Last post November 30, 2013, 02:55:09 pm
by alsled
394 Rebuild and BB

Started by alsled « 1 2 ... 5 6 » Husqvarna

51 Replies
870 Views
Last post June 13, 2014, 10:49:39 pm
by KilliansRedLeo
8 Replies
339 Views
Last post July 10, 2014, 10:13:35 am
by hadji
2 Replies
132 Views
Last post February 15, 2015, 03:08:29 pm
by wild262
2165 Rebuild

Started by mdavlee . « 1 2 3 » Jonsered

22 Replies
827 Views
Last post January 09, 2016, 11:33:44 am
by mdavlee .
3 Replies
231 Views
Last post March 05, 2016, 10:21:43 pm
by jmester