Author Topic: 46cc Poulan Carb Mount Mod  (Read 1508 times)

0 Members and 16 Guests are viewing this topic.

Offline Chris-PA

  • 6 cube
  • ****
  • Posts: 209
  • Karma: 32

  • Total Badges: 21
    Badges: (View All)
    Level 5 Third year Anniversary Second year Anniversary 100 Posts 50 Posts Level 4
Re: 46cc Poulan Carb Mount Mod
« on: September 04, 2015, 04:46:52 pm »
Last, I bought a couple of the carb isolator/supports used on the later Type 3 & 4 saws.  I have no idea where they are supposed to go, but the whole carb arrangement on this saw clearly needs some support at the front edge, so I wedged it under the bottom of the air filter mount.  My Husky 142 has a bracket on the front of the carb.  Previously when I would run the saw without the top cover on the whole carb would vibrate all around.  The top cover helps to support it but after a while it wears a groove in the rubber partition seal (if you epoxy it on that is, otherwise they just fall off). 

 

Related Topics

  Subject / Started by Replies Last post
5 Replies
929 Views
Last post December 31, 2012, 12:55:16 pm
by Chris J.
36 Replies
2033 Views
Last post July 16, 2014, 07:18:19 pm
by Cut4fun
68 Replies
3562 Views
Last post August 01, 2016, 10:02:15 pm
by 3000 FPS
33 Replies
3638 Views
Last post August 30, 2014, 01:40:43 pm
by 660magnum
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
3168 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
13 Replies
1080 Views
Last post March 26, 2017, 03:06:09 pm
by Revpop
5 Replies
371 Views
Last post December 11, 2015, 05:11:29 pm
by jrbarba
4 Replies
854 Views
Last post October 14, 2016, 12:25:30 pm
by Cut4fun .
26 Replies
1964 Views
Last post March 03, 2020, 03:07:26 pm
by Cut4fun .
2 Replies
328 Views
Last post September 18, 2021, 08:00:25 am
by Cut4fun