Author Topic: Poulan 2800  (Read 3230 times)

0 Members and 46 Guests are viewing this topic.

Offline brokenbudget

  • Nitro Hotsaw
  • *******
  • Posts: 900
  • Karma: 67
  • Location: brockville ontario canada

  • Total Badges: 32
    Badges: (View All)
    Seventh year Anniversary Level 6 Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary Linux User
Re: another 2800
« Reply #20 on: April 01, 2013, 10:32:25 pm »
i think my 640 has the same distributer. had a good friend thats rebuilds starters and distributers do this one about 5 years ago. just before winter, it started to burn up points and condensors. it would run for 30-40 seconds and then quit. you could clean up the points but the condensor needed to be replaced. had that freaking dist. out probably 6 times before we found it had nothing to do with it. the neg. wire going to the dist. was shorting against the coil wire. shortened the coile wire so it wasn't drooping down and taped up the neg. wire and she ran once again.
of course i noticed she was dripping oil from under in the clutch area after a towed the major back. great, need to do the rear main seal on that when it dries up outside. they're easy. and thankfully cheap.
i'd still rather work on these than a mini mac :D
when I grow up, i wanna be an adult.

 

Related Topics

  Subject / Started by Replies Last post
1 Replies
672 Views
Last post December 11, 2012, 04:27:45 pm
by Cut4fun .
44 Replies
3304 Views
Last post July 26, 2015, 05:45:30 pm
by Cut4fun .
4 Replies
1307 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
3502 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
31 Replies
2381 Views
Last post June 29, 2016, 08:15:33 pm
by countryhog
2 Replies
263 Views
Last post February 24, 2013, 02:40:52 am
by brokenbudget
2 Replies
377 Views
Last post September 13, 2013, 02:57:45 pm
by KilliansRedLeo
0 Replies
207 Views
Last post February 13, 2021, 08:08:23 am
by Cut4fun
0 Replies
88 Views
Last post November 25, 2023, 08:49:58 am
by Cut4fun
0 Replies
26 Views
Last post January 07, 2024, 07:54:22 am
by Cut4fun