« previous next »
Pages: 1 2 3 [4] 5 6 7 8   Go Down

Author Topic: Craftsman Poulan 25 25D S25 S25D CVA Top Handle  (Read 3613 times)

0 Members and 65 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2117
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming

    • Total Badges: 37
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary
Re: Blue Red Yellow 38cc Top Handles
« Reply #30 on: October 23, 2016, 08:18:58 pm »
Quote from: Cut4fun . on October 23, 2016, 08:12:17 pm
Think I am going to put a 3/8LP on the 2 roller nose bars that had 1/4.  Have 2 3.8lp spur 6 and the red one is rim 3/8lp 7

Any idea the drive link count on these rollernose bars?

If they're 16" then they should be 56DL.  Could be 57DL too.  Seen both on these saws.  The Windsor Mini-Pro 16" bar on my 2.3PS/VL took 57DL of LP.  It's the rim drive like yours (9 spline), so it should be 7 pin.
Logged
Pages: 1 2 3 [4] 5 6 7 8   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
26 Replies
1753 Views 		Last post March 05, 2013, 06:49:29 pm
by 3000 FPS
18 Replies
1318 Views 		Last post January 25, 2014, 08:03:36 am
by The Ripper
5 Replies
396 Views 		Last post September 21, 2014, 09:58:50 am
by stubnail67
4 Replies
783 Views 		Last post January 04, 2015, 11:28:15 am
by Philbert
9 Replies
647 Views 		Last post February 04, 2015, 12:37:31 pm
by Cut4fun .
1 Replies
377 Views 		Last post February 09, 2017, 12:26:19 pm
by Cut4fun .
6 Replies
1738 Views 		Last post July 16, 2016, 08:34:33 pm
by TedB.
1 Replies
364 Views 		Last post January 15, 2017, 03:44:55 pm
by Cut4fun .
2 Replies
323 Views 		Last post November 11, 2017, 02:42:19 pm
by farmboy
0 Replies
183 Views 		Last post November 24, 2017, 07:45:51 pm
by AmericanPsycho