« previous next »
Pages: [1]   Go Down

Author Topic: Carburetor removal Craftsman 3.3  (Read 477 times)

0 Members and 44 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Carburetor removal Craftsman 3.3
« on: June 23, 2015, 11:08:38 pm »
I usually blow the filters off with compressed air.

The anti vibration buffers at the bottom are rubber.   They have a screw thru the center of a black cap.   After removing the screw you can pry out the plastic cap.  The other anti vibration buffers are springs.   

That should make a good starter saw.    When you take the carb apart make sure to pay attention to the order of the diaphragms and gaskets.
Logged
PP 505, 475, 445.
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
22 Replies
3670 Views 		Last post September 20, 2014, 06:12:53 pm
by aclarke
0 Replies
623 Views 		Last post January 21, 2012, 08:10:35 pm
by tommyhnavix
9 Replies
624 Views 		Last post July 10, 2012, 01:18:00 pm
by Al Smith
15 Replies
1065 Views 		Last post December 05, 2014, 01:30:49 pm
by aclarke
7 Replies
486 Views 		Last post April 03, 2015, 12:35:32 pm
by AmericanPsycho
18 Replies
1582 Views 		Last post July 27, 2015, 02:48:45 pm
by John Mc
0 Replies
196 Views 		Last post July 01, 2017, 07:18:58 pm
by AmericanPsycho
19 Replies
1020 Views 		Last post July 20, 2017, 10:44:28 am
by HolmenTree
3 Replies
1200 Views 		Last post February 08, 2020, 07:19:31 am
by Cut4fun .
2 Replies
350 Views 		Last post December 29, 2021, 10:13:33 am
by pmeyers