Author Topic: Check Valve poulan micro saws  (Read 1417 times)

0 Members and 2 Guests are viewing this topic.

Offline ChipsAhoy

  • 4 cube
  • **
  • Posts: 39
  • Karma: 4
Re: Check Valve poulan micro saws
« on: May 08, 2015, 05:18:00 pm »
Well I just tried dis-assembling one like the above instructions and it's a lot harder then it appears.

#1- trying to roll back the lip that holds the screen is very touchy. When I tried to pry the roll over up, it would break off. I got most of it up a little but like I said it'll break off if you try to go too much w/it. After breaking off about 1/3 of it during the process, the screen was loose enough to get out. I have to believe the rest will break when I try to crimp it again.  We'll see.

#2- the so called brass bushing was not in mine. If there is a bushing, I don't know how to get it out. It has to be a very tight press fit. I might have an earlier version that don't have the brass.  Mine looks like all the same material. I can feel a small ridge under it but I gave up trying to remove it for fear of destroying the valve. I even tried the drywall screw method, no dice.

I have a couple duckbills ordered, so when they come in we'll see where this takes me. 

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
879 Views
Last post December 04, 2013, 07:35:40 am
by doreadeal
Poulan Micro

Started by fossil « 1 2 » Poulan

14 Replies
447 Views
Last post May 08, 2020, 06:40:50 am
by Cut4fun .
Poulan micro XXV

Started by countryhog « 1 2 » Poulan

10 Replies
510 Views
Last post August 01, 2014, 09:45:30 pm
by Cut4fun .
20 Replies
657 Views
Last post September 09, 2015, 02:29:33 pm
by 94BULLITT
37 Replies
1154 Views
Last post June 17, 2017, 09:24:24 am
by Cut4fun .
6 Replies
443 Views
Last post November 16, 2016, 01:09:22 pm
by Cut4fun .
2 Replies
213 Views
Last post January 07, 2018, 08:12:37 pm
by jmester
6 Replies
254 Views
Last post January 02, 2019, 01:01:25 pm
by trappermike
8 Replies
269 Views
Last post January 14, 2019, 10:03:10 am
by trappermike
3 Replies
47 Views
Last post April 06, 2020, 07:47:38 am
by Cut4fun .