Author Topic: Chrome Poulan  (Read 414 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Chrome Poulan
« Reply #20 on: October 26, 2013, 02:50:59 am »
Hiya Tim.  Look in my post above^^^.  That's where I'd mentioned receiving the red S25-CVA.  Couldn't remember what thread I'd posted it in..... ::)
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline fossil

  • 6 cube
  • ****
  • Posts: 198
  • Karma: 59
  • Location: Brampton, Ontario
Re: Chrome Poulan
« Reply #21 on: October 26, 2013, 06:48:58 pm »
I did clean it up some and drained the bar oil. I didn't want to send you a bunch of old saw cake.
I'm glad you like it. It appears to be a nice little saw.

Tim
Tim

 

Related Topics

  Subject / Started by Replies Last post
Poulan 415

Started by Cut4fun « 1 2 ... 11 12 » Poulan

114 Replies
3702 Views
Last post May 28, 2020, 09:41:14 pm
by 3000 FPS
Poulan 445

Started by 3000 FPS « 1 2 ... 17 18 » Poulan

177 Replies
4530 Views
Last post June 20, 2020, 12:21:47 pm
by Cut4fun .
7 Replies
519 Views
Last post April 13, 2014, 08:11:42 pm
by Cut4fun .
0 Replies
190 Views
Last post October 02, 2012, 11:36:18 am
by mweba
Poulan 395

Started by 3000 FPS « 1 2 3 » Poulan

23 Replies
977 Views
Last post January 05, 2013, 09:09:29 pm
by 3000 FPS
4 Replies
538 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1188 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
Poulan 335

Started by 3000 FPS « 1 2 3 4 5 » Poulan

46 Replies
1313 Views
Last post February 14, 2020, 09:23:59 am
by Cut4fun .
Poulan 380

Started by Cut4fun . « 1 2 ... 7 8 » Poulan

78 Replies
2085 Views
Last post March 01, 2020, 08:06:34 am
by Cut4fun .
14 Replies
752 Views
Last post May 10, 2019, 06:39:19 am
by Al Smith