« previous next »
Pages: 1 [2] 3 4 5 6   Go Down

Author Topic: Craftsman 2.3 like a Poulan 2300cva  (Read 3582 times)

0 Members and 58 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23744
  • Karma: 664
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair

    • Total Badges: 53
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 8 Apple User Eighth year Anniversary 20000 Posts
Re: Craftsman like a 2300cva
« Reply #10 on: July 17, 2014, 09:10:07 pm »
I put the carb on the 1800 I pulled the good carb off of.  Same results but not as bad on the rev.  Thinking it was the throttle plate hung up some.

Roger can I get a pic of the av's on your saw?   Poulan 2300 firewood type III  , 2300 CVA  Trying to figure out why so many metal washers used upper and lower. 
Sure was smooth in the cut compared to the no av 2000 1800 etc.


Logged
Pages: 1 [2] 3 4 5 6   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
3 Replies
699 Views 		Last post February 08, 2012, 04:16:23 pm
by Cut4fun .
1 Replies
713 Views 		Last post October 18, 2012, 04:02:23 pm
by Cut4fun .
6 Replies
518 Views 		Last post May 01, 2013, 03:19:29 pm
by Cut4fun .
18 Replies
1312 Views 		Last post January 25, 2014, 08:03:36 am
by The Ripper
4 Replies
783 Views 		Last post January 04, 2015, 11:28:15 am
by Philbert
9 Replies
646 Views 		Last post February 04, 2015, 12:37:31 pm
by Cut4fun .
2300CVA

Started by leec « 1 2 » Poulan

17 Replies
935 Views 		Last post September 24, 2015, 03:47:45 pm
by Eccentric
6 Replies
1737 Views 		Last post July 16, 2016, 08:34:33 pm
by TedB.
2 Replies
323 Views 		Last post November 11, 2017, 02:42:19 pm
by farmboy
0 Replies
182 Views 		Last post November 24, 2017, 07:45:51 pm
by AmericanPsycho