Author Topic: cylinder / piston interchange  (Read 2520 times)

0 Members and 13 Guests are viewing this topic.

Offline dannyupsolate

  • Piped Saw
  • *****
  • Posts: 328
  • Karma: 28

  • Total Badges: 18
    Badges: (View All)
    Third year Anniversary Karma Good Level 4 Second year Anniversary Poll Voter One year Anniversary
Re: cylinder / piston interchange
« on: January 12, 2016, 01:24:32 am »
As far as I know good modern oil at 32 to 1 is good in all saws. Should make that aluminum cylinder last far longer than manufacturer intended. You are correct to much oil can cause problems but 32 to 1 is not to much. I scrap out lots of poulans its always fuel lines, bad gas,carburetor trouble, or lean mixture and every ones favorite straight gas. Once in a while bad magneto. Adjust your carburetor to where it four strokes a little at wide open throttle and cleans up to two stroke in the wood. Put some of the good stihl chain on the guys here been testing and let your poulan rip

 

Related Topics

  Subject / Started by Replies Last post
0 Replies
473 Views
Last post May 24, 2012, 08:20:22 pm
by MP5N
19 Replies
1408 Views
Last post September 09, 2013, 09:51:10 pm
by doreadeal
1 Replies
383 Views
Last post March 11, 2014, 04:13:31 pm
by Cut4fun .
12 Replies
923 Views
Last post December 15, 2014, 05:25:46 am
by Eccentric
0 Replies
352 Views
Last post September 26, 2015, 10:29:23 pm
by 660magnum
7 Replies
780 Views
Last post January 18, 2016, 12:54:40 pm
by randy_das
5 Replies
436 Views
Last post May 09, 2017, 09:44:40 am
by Nathaniel Vansickle
1 Replies
1836 Views
Last post September 20, 2018, 04:08:33 pm
by Cut4fun .
3 Replies
457 Views
Last post April 01, 2020, 11:15:27 am
by pleasant
0 Replies
141 Views
Last post March 28, 2022, 08:09:50 am
by Cut4fun