Author Topic: Poulan Jonsered Plastic clutch cover wear 415 425 445 475 505 2077 2083 2083II  (Read 1529 times)

0 Members and 4 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23242
  • Karma: 650
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Plastic clutch cover wear
« on: April 10, 2013, 01:08:13 pm »
I can verify that the one cover in the middle had a bar plate on it.

I was hoping you knew. 

Here is the outer cover bar plates.   I'm not sure on all the husqvarnas that used this plate but here is my guesses.  husky 266 61 268 2100 272 66 part # 501444501

I am thinking of the ones with the wear. Grinding them down flat again and use outer  bar plates.   Should work wouldnt you think?

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
14 Replies
1805 Views
Last post September 02, 2021, 07:24:58 am
by Cut4fun .
38 Replies
1987 Views
Last post June 21, 2016, 01:32:54 pm
by Cut4fun .
4 Replies
600 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
1 Replies
353 Views
Last post May 24, 2018, 09:28:10 pm
by Cut4fun .
6 Replies
439 Views
Last post July 22, 2017, 12:54:36 pm
by 3000 FPS
21 Replies
1335 Views
Last post December 03, 2022, 07:42:58 am
by Cut4fun .
15 Replies
822 Views
Last post November 16, 2018, 02:56:14 pm
by Cut4fun .
3 Replies
334 Views
Last post October 23, 2018, 11:16:06 am
by Cut4fun .
11 Replies
688 Views
Last post July 15, 2022, 09:41:07 am
by Cut4fun .
0 Replies
84 Views
Last post January 07, 2022, 02:14:33 pm
by Cut4fun .