Author Topic: Poulan Jonsered Plastic clutch cover wear 415 425 445 475 505 2077 2083 2083II  (Read 2124 times)

0 Members and 33 Guests are viewing this topic.

Offline farmboy

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1170
  • Karma: 150
  • Location: Hayesville, NC

  • Total Badges: 31
    Badges: (View All)
    Level 6 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary 1000 Posts Old Browser
Re: Plastic clutch cover wear
« on: April 11, 2013, 09:00:56 am »
I can verify that the one cover in the middle had a bar plate on it.

I was hoping you knew. 

Here is the outer cover bar plates.   I'm not sure on all the husqvarnas that used this plate but here is my guesses.  husky 266 61 268 2100 272 66 part # 501444501

I am thinking of the ones with the wear. Grinding them down flat again and use outer  bar plates.   Should work wouldnt you think?


I ran across 501-4444-01 Inner 501-4445-01 Outer in IPL used on D007 Poulan bars.  Don't remember where I ran across it.  Agree it should work fine.
I put em on all my 266,268,272,61 Huskys.  Don't have any big Poulans                                    Yet. ;D
Shep

 

Related Topics

  Subject / Started by Replies Last post
20 Replies
2614 Views
Last post February 09, 2024, 08:47:00 am
by Cut4fun .
38 Replies
3382 Views
Last post June 21, 2016, 01:32:54 pm
by Cut4fun .
4 Replies
963 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
1 Replies
524 Views
Last post May 24, 2018, 09:28:10 pm
by Cut4fun .
6 Replies
688 Views
Last post July 22, 2017, 12:54:36 pm
by 3000 FPS
22 Replies
2133 Views
Last post February 26, 2024, 06:51:11 am
by Cut4fun
15 Replies
1443 Views
Last post November 16, 2018, 02:56:14 pm
by Cut4fun .
3 Replies
536 Views
Last post October 23, 2018, 11:16:06 am
by Cut4fun .
13 Replies
1123 Views
Last post February 26, 2024, 10:49:43 am
by Cut4fun .
0 Replies
179 Views
Last post January 07, 2022, 02:14:33 pm
by Cut4fun .