Author Topic: Poulan 2150 fuel line routing  (Read 2091 times)

0 Members and 30 Guests are viewing this topic.

Offline leec

  • 6 cube
  • ****
  • Posts: 264
  • Karma: 14
  • Location: Huntsville, Ontario

  • Total Badges: 23
    Badges: (View All)
    Sixth year Anniversary Fifth year Anniversary Level 5 Fourth year Anniversary Third year Anniversary 100 Posts
Re: Poulan 2150 fuel line routing
« Reply #20 on: November 23, 2015, 08:35:41 am »
Just working on a 2150 and the filter was on B although line A was also long enough in the tank to be the fuel line. Line B in my saw had a joiner on the line just inside the tank as if it was acting as a seal pulled up into the line opening in the tank case.  P&C good on the 2150.  I find these to be better saws than the later ones. The IPLs are useless.

I also picked up a Stratos saw at the same time but it runs so I can just follow the existing lines

 

Related Topics

  Subject / Started by Replies Last post
20 Replies
6198 Views
Last post January 29, 2024, 02:44:18 pm
by Cut4fun .
2 Replies
791 Views
Last post March 28, 2012, 12:27:35 pm
by nmurph
2 Replies
730 Views
Last post August 26, 2013, 01:39:22 pm
by Bluegill
162 Replies
7545 Views
Last post August 24, 2023, 10:20:50 am
by Cut4fun
9 Replies
2579 Views
Last post April 18, 2014, 01:04:51 am
by Phillip Guidry
15 Replies
4740 Views
Last post April 30, 2014, 11:58:07 pm
by Eccentric
25 Replies
1158 Views
Last post November 07, 2015, 07:25:01 pm
by treeslayer2003
5 Replies
497 Views
Last post November 18, 2015, 12:19:22 pm
by Cut4fun .
11 Replies
1178 Views
Last post June 08, 2016, 01:58:07 pm
by Cut4fun
12 Replies
823 Views
Last post June 10, 2019, 10:46:53 am
by AmericanPsycho