Author Topic: Poulan 3000 to 3400  (Read 624 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22191
  • Karma: 560
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 3000 to 3400
« Reply #10 on: April 13, 2014, 07:28:49 pm »
I was comparing a 335 54cc and 380 60cc cylinder yesterday. The inside measurement of front holes was about 3mm narrower total on 3000 49cc cyl going by inside side of hole.

So thinking just slotting the 380 holes this would bolt on after that.

One could use the bigger intake boot and carb too for little more gains.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
60 Replies
2647 Views
Last post November 12, 2015, 07:36:52 pm
by 3000 FPS
44 Replies
1894 Views
Last post July 26, 2015, 05:45:30 pm
by Cut4fun .
Poulan 3400

Started by JGB66 « 1 2 » Poulan

11 Replies
691 Views
Last post January 16, 2018, 03:15:59 pm
by Cut4fun .
2 Replies
164 Views
Last post September 13, 2013, 02:57:45 pm
by KilliansRedLeo
18 Replies
428 Views
Last post January 25, 2014, 08:03:36 am
by The Ripper
1 Replies
203 Views
Last post April 11, 2014, 10:55:57 pm
by Cut4fun .
POULAN 3400

Started by redunshee « 1 2 » Poulan

12 Replies
191 Views
Last post February 17, 2014, 11:30:27 pm
by Eccentric
3 Replies
161 Views
Last post November 08, 2014, 08:11:47 pm
by Cut4fun .
Poulan 3000

Started by Drew_Uth « 1 2 ... 6 7 » Poulan

63 Replies
1084 Views
Last post September 11, 2020, 02:40:03 pm
by Cut4fun
1 Replies
29 Views
Last post September 18, 2020, 02:36:28 pm
by Cut4fun .