Author Topic: Poulan 315 50th anniversary edition  (Read 725 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Poulan 315 50th anniversary edition
« Reply #20 on: July 06, 2018, 02:31:50 am »
Thread Revival!
I got a PP 315 50th Ann in a lot of saws I bought. Seems like it will be a competent saw. Donít know too much yet - need new clutch, sprocket and starter pulley.
How do they pull 18ď .325?
Thinking about trying 3/8LP. It has a K041 bar but bet A041 will work.
Clutch drum is 67mm OD and bearing is 13mm OD. Seeing if I can find a rim sprocket like that to take a 3/8LP rim.

Don't know.  I don't think I know anyone that has ran a 49cc PP315, PP310, or 3050.  The 46cc saws will run an 18" .325 pitch bar fairly well, especially after the muffler's opened up a bit.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21948
  • Karma: 533
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 315 50th anniversary edition
« Reply #21 on: July 16, 2020, 09:56:10 am »
Guy listing this poulan 315 50th on CRG FS

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
Poulan 425

Started by Cut4fun « 1 2 » Poulan

15 Replies
1079 Views
Last post March 18, 2014, 02:19:35 pm
by Cut4fun .
17 Replies
768 Views
Last post May 24, 2017, 06:52:22 pm
by 3000 FPS
Poulan 445

Started by 3000 FPS « 1 2 ... 18 19 » Poulan

181 Replies
4568 Views
Last post August 01, 2020, 08:05:18 am
by Cut4fun
7 Replies
521 Views
Last post April 13, 2014, 08:11:42 pm
by Cut4fun .
0 Replies
191 Views
Last post October 02, 2012, 11:36:18 am
by mweba
4 Replies
542 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1203 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
11 Replies
1003 Views
Last post October 06, 2013, 10:12:00 pm
by stihls066
3 Replies
136 Views
Last post September 25, 2017, 08:10:47 am
by pete
0 Replies
164 Views
Last post October 21, 2017, 10:25:14 pm
by Cut4fun .