« previous next »
Pages: [1]   Go Down

Author Topic: Poulan 3400 cylinder porting  (Read 890 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 23417
  • Karma: 662
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 3400 cylinder porting
« on: February 27, 2013, 04:19:14 pm »
Quote from: magnumfloyd on February 27, 2013, 04:10:03 pm
Does any one have a pictures or tips to share I'm planning on removing base gasket and sealing with three bond 1184

Check your squish just to be safe, even though it should be fine without the gasket on these.  I use ThreeBond 1194 when not using gaskets.

I take it you just reused your cylinder and didnt want this one I had for shipping?
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
60 Replies
4364 Views 		Last post November 12, 2015, 07:36:52 pm
by 3000 FPS
Poulan 3400

Started by JGB66 « 1 2 » Poulan

11 Replies
1272 Views 		Last post January 16, 2018, 03:15:59 pm
by Cut4fun .
6 Replies
848 Views 		Last post October 15, 2013, 06:19:26 pm
by Al Smith
0 Replies
131 Views 		Last post December 15, 2013, 06:21:45 pm
by Eccentric
11 Replies
581 Views 		Last post March 15, 2014, 11:59:03 pm
by bustedknuckles
16 Replies
1258 Views 		Last post April 15, 2014, 08:29:22 pm
by Tractorsaw1
19 Replies
2790 Views 		Last post May 22, 2019, 10:19:04 am
by Cut4fun .
POULAN 3400

Started by redunshee « 1 2 » Poulan

12 Replies
502 Views 		Last post February 17, 2014, 11:30:27 pm
by Eccentric
0 Replies
139 Views 		Last post October 10, 2021, 11:12:22 am
by Cut4fun .
0 Replies
165 Views 		Last post December 22, 2022, 07:56:33 am
by Cut4fun