Author Topic: poulan 3400 dawgs  (Read 231 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: poulan 3400 dawgs
« on: November 23, 2014, 03:13:52 pm »
Yep.  Single.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
60 Replies
2523 Views
Last post November 12, 2015, 07:36:52 pm
by 3000 FPS
Poulan 3400

Started by JGB66 « 1 2 » Poulan

11 Replies
650 Views
Last post January 16, 2018, 03:15:59 pm
by Cut4fun .
6 Replies
511 Views
Last post September 13, 2013, 12:49:19 pm
by 3000 FPS
16 Replies
573 Views
Last post April 15, 2014, 08:29:22 pm
by Tractorsaw1
POULAN 3400

Started by redunshee « 1 2 » Poulan

12 Replies
183 Views
Last post February 17, 2014, 11:30:27 pm
by Eccentric
14 Replies
369 Views
Last post January 12, 2015, 02:23:43 pm
by countryhog
5 Replies
1213 Views
Last post February 23, 2016, 11:10:39 am
by countryhog
0 Replies
87 Views
Last post March 26, 2018, 03:35:00 pm
by dano
2 Replies
102 Views
Last post February 11, 2019, 09:27:39 pm
by Cut4fun .
3 Replies
113 Views
Last post November 22, 2019, 09:18:33 am
by Cut4fun .