« previous next »
Pages: [1] 2 3 4 5 6 ... 8   Go Down

Author Topic: Poulan 3450 Carb issues  (Read 3213 times)

0 Members and 36 Guests are viewing this topic.

Offline 660magnum

  • Global Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 6437
  • Karma: 249
  • For The Love Of Chainsaws
  • Location: NCO

    • Total Badges: 39
    Badges: (View All)
    Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary Fourth year Anniversary 5000 Posts Third year Anniversary
Re: Poulan 3450 Carb issues
« on: October 06, 2014, 02:40:54 pm »
The "L" mixture needle should be used to make the engine run correctly at the lowest speeds.

The big idle speed screw should then be used to control the idle speed.  The correct idle speed is just slower than where the chain begins to spin.

I have a Poulan 3500 that is a lot like your 3450 (the same age) and I had to replace the carburetor diaphragms three years ago. I've had to replace the fuel filter in the tank three times over the years.
Logged
We should share what we know... someone may learn...
That knowledge can live after us... and that "Pays It Forward".
Be all that you can be . . .
Pages: [1] 2 3 4 5 6 ... 8   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
Poulan 330 3450

Started by Cut4fun . « 1 2 ... 44 45 » Poulan

442 Replies
20463 Views 		Last post June 24, 2022, 07:37:03 am
by Cut4fun .
13 Replies
4075 Views 		Last post January 25, 2012, 07:21:50 pm
by Al Smith
5 Replies
1255 Views 		Last post February 21, 2012, 01:29:32 pm
by 660magnum
3 Replies
1058 Views 		Last post February 03, 2013, 06:33:10 pm
by 660magnum
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
4131 Views 		Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
1 Replies
364 Views 		Last post January 07, 2014, 11:00:02 pm
by jmester
16 Replies
2794 Views 		Last post April 11, 2014, 07:03:51 am
by Tractorsaw1
17 Replies
2228 Views 		Last post September 15, 2014, 12:30:02 pm
by 660magnum
5 Replies
909 Views 		Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
120 Replies
5465 Views 		Last post October 07, 2023, 08:09:15 am
by Cut4fun