Author Topic: Poulan 3450 - cylinder, gasket and piston  (Read 303 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22134
  • Karma: 552
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 3450 - cylinder, gasket and piston
« Reply #10 on: March 14, 2015, 05:17:22 pm »
If the ring pin was on the side you were good since not in ext opening.  I have had a racesaw that ran a piston backwards before so it cleared external transfers etc.  But it wasnt located in the exhaust opening either.
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
Poulan 330 3450

Started by Cut4fun . « 1 2 ... 33 34 » Poulan

330 Replies
10096 Views
Last post March 03, 2020, 03:15:53 pm
by Cut4fun .
3 Replies
362 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
0 Replies
193 Views
Last post February 20, 2013, 09:38:25 pm
by tommysp61
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
1402 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
1100 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
336 Views
Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
2 Replies
186 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
8 Replies
222 Views
Last post June 05, 2015, 09:52:30 am
by Cut4fun .
4 Replies
312 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
3 Replies
298 Views
Last post November 21, 2016, 02:29:41 pm
by Cut4fun .