Author Topic: Poulan 3450 - cylinder, gasket and piston  (Read 303 times)

0 Members and 0 Guests are viewing this topic.

Offline rockfishon

  • 4 cube
  • **
  • Posts: 59
  • Karma: 8
Re: Poulan 3450 - cylinder, gasket and piston
« Reply #10 on: March 16, 2015, 07:25:34 pm »
So during all of the carb testing and head removal  I noticed pressure in the gas tank.  Decided to replace the vent plug.  Only problem is I had to disassemble everything again to get to it.  Drilled a small pilot hole and put in a screw.  Popped right out.  The new one seems to just drop in and is loose.  If I was to turn the saw over it would fall out.  How do I get it to stay in place?  Any secrets?  Did I get the wrong part?

 

Related Topics

  Subject / Started by Replies Last post
Poulan 330 3450

Started by Cut4fun . « 1 2 ... 33 34 » Poulan

330 Replies
10090 Views
Last post March 03, 2020, 03:15:53 pm
by Cut4fun .
3 Replies
362 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
0 Replies
193 Views
Last post February 20, 2013, 09:38:25 pm
by tommysp61
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
1402 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
1100 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
336 Views
Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
2 Replies
186 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
8 Replies
222 Views
Last post June 05, 2015, 09:52:30 am
by Cut4fun .
4 Replies
312 Views
Last post October 19, 2018, 03:18:46 pm
by Cut4fun .
3 Replies
296 Views
Last post November 21, 2016, 02:29:41 pm
by Cut4fun .