Author Topic: Poulan 3450 3750 and PoulanPro 330 380 Tank Vent Retrofit  (Read 2742 times)

0 Members and 11 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2117
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming

  • Total Badges: 37
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary
That piece is optional......and unneeded in my opinion.  Was never used on the many thousands of 3400-4000/PP375-395 saws.  They all had this same style of vent.  I didn't use one on my PP330 when I refitted it either.  I just left that end of the line cut at an angle on my saws.

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
4290 Views
Last post April 23, 2013, 04:21:14 pm
by Go JayBee
120 Replies
5385 Views
Last post October 07, 2023, 08:09:15 am
by Cut4fun
2 Replies
594 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
2 Replies
456 Views
Last post September 28, 2015, 12:40:53 pm
by Cut4fun .
17 Replies
1035 Views
Last post December 06, 2017, 05:58:03 pm
by Cut4fun .
17 Replies
1270 Views
Last post January 14, 2024, 03:14:04 pm
by Cut4fun .
0 Replies
448 Views
Last post August 31, 2018, 06:26:35 pm
by Cut4fun .
0 Replies
243 Views
Last post November 25, 2020, 08:52:46 am
by Cut4fun .
0 Replies
192 Views
Last post March 03, 2022, 10:55:02 am
by Cut4fun .
1 Replies
29 Views
Last post February 03, 2024, 10:57:09 am
by Cut4fun