Author Topic: Poulan 3450 3750 and PoulanPro 330 380 Tank Vent Retrofit  (Read 1249 times)

0 Members and 0 Guests are viewing this topic.

Offline farmboy

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 1170
  • Karma: 150
  • Location: Hayesville, NC
That piece is optional......and unneeded in my opinion.  Was never used on the many thousands of 3400-4000/PP375-395 saws.  They all had this same style of vent.  I didn't use one on my PP330 when I refitted it either.  I just left that end of the line cut at an angle on my saws.

I reuse it if it's still there.  If not no big deal IMO.  I think I only have 1 out of 10-12 that has it installed. 
Shep

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
2706 Views
Last post April 23, 2013, 04:21:14 pm
by Go JayBee
111 Replies
2008 Views
Last post September 27, 2015, 09:41:29 pm
by 3000 FPS
18 Replies
274 Views
Last post March 22, 2015, 09:43:31 pm
by 3000 FPS
2 Replies
209 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
2 Replies
191 Views
Last post September 28, 2015, 12:40:53 pm
by Cut4fun .
4 Replies
170 Views
Last post November 22, 2015, 11:58:01 am
by Cut4fun .
17 Replies
321 Views
Last post December 06, 2017, 05:58:03 pm
by Cut4fun .
15 Replies
347 Views
Last post March 17, 2021, 08:07:15 am
by Cut4fun
0 Replies
132 Views
Last post August 31, 2018, 06:26:35 pm
by Cut4fun .
0 Replies
49 Views
Last post November 25, 2020, 08:52:46 am
by Cut4fun .