Author Topic: Poulan 3450 3750 and PoulanPro 330 380 Tank Vent Retrofit  (Read 2737 times)

0 Members and 29 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4666
  • Karma: 216
  • OHIO REDNECK

  • Total Badges: 44
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Level 7 Seventh year Anniversary Apple User
The 2700 I just got in trade. 1st thing I did was pull all the lines, tank vent and fuel were all wrong. Will pull impulse line later to replace.

Just for learning. The fuel line was run through the tank vent area hole (forward hole) and fuel line was cut in half with plastic nipple installed on wrong side of tank. It goes inside tank with duckbill valve inside tank then line running up over behind carb area to make up tank vent.

The fuel line goes in rear hole with one line to carb. 

Least all of the ones I paid attention to have been this way. I even pulled to check the grey 3.0 3000 down beside it to make sure.

 

Related Topics

  Subject / Started by Replies Last post
7 Replies
4287 Views
Last post April 23, 2013, 04:21:14 pm
by Go JayBee
120 Replies
5367 Views
Last post October 07, 2023, 08:09:15 am
by Cut4fun
2 Replies
594 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
2 Replies
456 Views
Last post September 28, 2015, 12:40:53 pm
by Cut4fun .
17 Replies
1031 Views
Last post December 06, 2017, 05:58:03 pm
by Cut4fun .
17 Replies
1269 Views
Last post January 14, 2024, 03:14:04 pm
by Cut4fun .
0 Replies
448 Views
Last post August 31, 2018, 06:26:35 pm
by Cut4fun .
0 Replies
243 Views
Last post November 25, 2020, 08:52:46 am
by Cut4fun .
0 Replies
192 Views
Last post March 03, 2022, 10:55:02 am
by Cut4fun .
1 Replies
29 Views
Last post February 03, 2024, 10:57:09 am
by Cut4fun