Author Topic: Poulan 3750 badboy 380 60cc  (Read 7778 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 4045
  • Karma: 159
  • OHIO REDNECK
Re: Poulan 3750 badboy 380 60cc
« Reply #10 on: November 10, 2011, 07:38:41 pm »
Now that other 3750 is fighting back some. The cylinder cleaned up great not noticeable at all and the piston has some noticeable carbon type marks but nothing to hang a nail on at all, even used old ring, it was just stuck (carbon IMO). Holds 150psi cold.

Need carb kit being it's not pulling fuel and runs on mix squirted in carb.

Ran new fuel line and had to install a new impulse nipple in carb HDA ( because plastic part of nipple was broke off in line) from a 066 carb had laying around. Will run new impulse line when carb removed this time.

For the life of me I cant find the tank vent on this one.  :-[ :-[  Another day.
REDNECK Saw Repair

 

Related Topics

  Subject / Started by Replies Last post
66 Replies
2127 Views
Last post March 03, 2020, 10:13:18 am
by Cut4fun .
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
1378 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
6 Replies
360 Views
Last post October 18, 2013, 06:56:49 am
by jmester
16 Replies
1001 Views
Last post April 11, 2014, 07:03:51 am
by Tractorsaw1
111 Replies
1292 Views
Last post September 27, 2015, 09:41:29 pm
by 3000 FPS
2 Replies
179 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
Poulan 3450 54cc 60cc

Started by Cut4fun « 1 2 3 4 5 » Poulan

43 Replies
717 Views
Last post November 02, 2015, 10:59:12 am
by Cut4fun .
2 Replies
135 Views
Last post February 28, 2018, 01:25:07 pm
by Cut4fun .
0 Replies
97 Views
Last post August 31, 2018, 06:26:35 pm
by Cut4fun .
0 Replies
20 Views
Last post February 10, 2020, 08:33:25 am
by Cut4fun .