Author Topic: Poulan 380  (Read 2085 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
Re: Poulan 380
« Reply #10 on: October 27, 2014, 06:31:27 pm »
Jon1212 has some NOS 24" K041 bars that were intended for these saws.  Possibly 20" and 22" too.
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
4 Replies
536 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1188 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
Poulan Micro

Started by fossil « 1 2 » Poulan

14 Replies
488 Views
Last post May 08, 2020, 06:40:50 am
by Cut4fun .
2 Replies
163 Views
Last post July 04, 2014, 02:27:26 pm
by Eccentric
2 Replies
109 Views
Last post July 26, 2014, 06:52:06 pm
by 3000 FPS
8 Replies
223 Views
Last post August 22, 2014, 02:09:00 pm
by AmericanPsycho
Poulan Pro 56cc

Started by mcbob « 1 2 » Poulan

16 Replies
310 Views
Last post October 10, 2014, 05:02:46 pm
by mcbob
20 Replies
414 Views
Last post December 29, 2014, 11:44:45 pm
by 3000 FPS
39 Replies
706 Views
Last post July 01, 2020, 08:03:22 am
by Cut4fun
Poulan S25DA Bow

Started by Cut4fun . « 1 2 3 » Poulan

23 Replies
364 Views
Last post January 05, 2015, 02:51:31 am
by Eccentric