« previous next »
Pages: 1 2 [3] 4 5 6 7 8   Go Down

Author Topic: Poulan 380  (Read 5766 times)

0 Members and 50 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

    • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Poulan 380
« Reply #20 on: April 04, 2015, 09:49:50 pm »
If you decide you want to weld it Aaron it is not a problem.   But the case has to be split and the oil line needs to be removed where it is close to that area.   Also the bearing should be removed because I will sand blast that area to get it clean and I can weld it.   No charge for the weld job.  That is very common and have seen that now on about 4 saws. 

The JB weld does work pretty good also.   
Logged
PP 505, 475, 445.
Winner Winner x 1 View List
Pages: 1 2 [3] 4 5 6 7 8   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
4 Replies
1304 Views 		Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
3497 Views 		Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
Poulan 3400XP

Started by Cut4fun . « 1 2 » Poulan

18 Replies
1819 Views 		Last post November 28, 2022, 02:45:19 pm
by Cut4fun .
Poulan 505

Started by 3000 FPS « 1 2 » Wanted

15 Replies
830 Views 		Last post June 05, 2014, 09:31:54 pm
by Cut4fun .
2 Replies
467 Views 		Last post July 04, 2014, 02:27:26 pm
by Eccentric
2 Replies
444 Views 		Last post July 26, 2014, 06:52:06 pm
by 3000 FPS
8 Replies
806 Views 		Last post August 22, 2014, 02:09:00 pm
by AmericanPsycho
Poulan Pro 56cc

Started by mcbob « 1 2 » Poulan

16 Replies
1038 Views 		Last post October 10, 2014, 05:02:46 pm
by mcbob
20 Replies
967 Views 		Last post December 29, 2014, 11:44:45 pm
by 3000 FPS
Poulan S25DA Bow

Started by Cut4fun . « 1 2 3 » Poulan

23 Replies
1255 Views 		Last post January 05, 2015, 02:51:31 am
by Eccentric