Author Topic: Poulan 8500 case repair  (Read 430 times)

0 Members and 0 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2111
  • Karma: 215
  • Magnesium and Iron.
  • Location: Northern California.
Re: Poulan 8500 case repair
« Reply #20 on: May 30, 2015, 02:51:07 pm »
No dice on the case gasket, are these available anywhere I am not looking at?  Any good substitute?  Thanks
I just bought 3-530019085 case gaskets.  Let me know if you need one.  My actual cost +ship.
Shep

Shep do you still have any of these gaskets to spare?
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
Poulan 8500

Started by Cut4fun « 1 2 ... 6 7 » Poulan

66 Replies
1592 Views
Last post November 15, 2018, 06:20:30 pm
by Cut4fun .
Poulan 5400 8500 5200

Started by Cut4fun « 1 2 ... 6 7 » Poulan

63 Replies
2302 Views
Last post March 09, 2019, 07:11:53 pm
by Cut4fun .
3 Replies
208 Views
Last post April 29, 2013, 12:34:45 am
by 3000 FPS
3 Replies
230 Views
Last post August 21, 2013, 10:36:49 am
by 3000 FPS
13 Replies
355 Views
Last post June 01, 2015, 03:20:32 pm
by 660magnum
4 Replies
229 Views
Last post August 09, 2015, 10:44:55 pm
by 3000 FPS
18 Replies
863 Views
Last post May 15, 2016, 05:29:20 am
by Eccentric
5 Replies
153 Views
Last post March 09, 2017, 01:48:40 am
by pete
4 Replies
93 Views
Last post October 02, 2017, 11:17:19 am
by fossil
0 Replies
55 Views
Last post February 08, 2019, 10:36:43 am
by Cut4fun