Author Topic: Poulan Bars OEM  (Read 511 times)

0 Members and 1 Guest are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 22076
  • Karma: 548
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan Bars OEM
« Reply #20 on: September 25, 2020, 06:38:11 pm »
Thinking of pulling some of my poulan K041 3/8 bar tips to convert over to more .325 tips.  Was just comparing.
One with oregon on it is a D009

2.5 wide mount area to 2 back. Just those older poulan 3/8 325 bars used narrow 9t and 10t. My later one used the 11t in 3/8 just like new Oregon.  Just found the narrow 3/8 9t nose on a old new Oregon I got just like those 3/8 older poulan bars

Info at start before finding above = Poulan bar that is 325 050 with replaceable tip 38019 .  It is  a solid Oregon powermatch bar relabeled but has a narrow tip.   Can that tip be replaced with the wider tip oregon 34775 .325 12T .
oregon s 35323 is a 325 10T too.   

REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
23 Replies
1248 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
14 Replies
2094 Views
Last post January 11, 2019, 03:34:31 pm
by Cut4fun .
17 Replies
898 Views
Last post December 02, 2013, 03:51:23 pm
by jmester
12 Replies
412 Views
Last post December 27, 2013, 10:04:43 am
by Cut4fun .
8 Replies
607 Views
Last post July 13, 2014, 12:16:19 pm
by Cut4fun .
5 Replies
160 Views
Last post January 02, 2018, 07:30:56 am
by Cut4fun .
7 Replies
160 Views
Last post February 23, 2018, 01:45:20 pm
by Cut4fun .
8 Replies
240 Views
Last post January 23, 2019, 09:20:10 pm
by trappermike
1 Replies
112 Views
Last post May 11, 2019, 09:49:35 am
by Cut4fun .
1 Replies
75 Views
Last post April 03, 2020, 12:03:39 am
by ssidwell