« previous next »
Pages: [1]   Go Down

Author Topic: Poulan Model 2300 CVA  (Read 767 times)

0 Members and 0 Guests are viewing this topic.

Offline TommyC

  • 3 cube
  • *
  • Posts: 19
  • Karma: 2
Re: Poulan Model 2300 CVA
« on: March 31, 2013, 07:55:20 pm »
So it sounds like BrokenBudget, Cut4fun & 660Magnum are saying that there is a tiny vent hole in the  bar oil tank to relieve pressure after the saw is shut down.  Who knew?  The pin does look bent to my eye but since it's no more critical than a "hole plug", I'll not fret over it.  It's good to finally know what in the devil it is.  (Thanks.)  I'll just leave it be ...

As for my saw not running and no fuel being sucked to the carb, does my approach seem reasonable:  Remove the carb, totally clean every port, and reassemble?

BTW, the  SS reed valve below the carb looked fine.  I carefully removed it to inspect; cleaned and & reinstalled.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics

  Subject / Started by Replies Last post
16 Replies
1556 Views 		Last post May 21, 2012, 05:10:04 pm
by man of stihl
97 Replies
4376 Views 		Last post September 18, 2013, 07:29:28 pm
by davbell22602
equivalent model

Started by jcsmith « 1 2 3 4 » Poulan

33 Replies
1351 Views 		Last post March 29, 2013, 06:50:08 am
by Al Smith
1 Replies
291 Views 		Last post February 28, 2013, 10:47:36 am
by 660magnum
3 Replies
281 Views 		Last post March 15, 2013, 07:41:16 am
by Hal
8 Replies
513 Views 		Last post May 02, 2013, 07:14:16 pm
by Cut4fun .
14 Replies
1223 Views 		Last post March 15, 2014, 08:17:42 pm
by 3000 FPS
4 Replies
238 Views 		Last post August 07, 2015, 04:45:49 pm
by leec
3 Replies
551 Views 		Last post December 30, 2015, 06:05:30 pm
by 3000 FPS
5 Replies
233 Views 		Last post March 11, 2017, 09:57:20 pm
by Cut4fun .