Author Topic: Poulan oiler 3400 3700 3800 4000 375 385 395 3.0 3.4 3.7  (Read 1428 times)

0 Members and 1 Guest are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2110
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northern California.
A little late on this one fellows.  I should have shared the contact information earlier.  FWIW the material is excellent.


Here is the contact information.

Company and Sales Manager in Burnaby, BC: http://www.neseal.com/index.php?option=com_contact&task=view&contact_id=4&Itemid=224

Product: http://www.robco.com/content/view/339/87/

I was given the go ahead to post by the company. I was able to purchase a smaller amount and have it shipped. Thao said she can accomodate others when necessary. Give her a call.


I have been experimenting with making the diaphragms and find punching out the impulse and screw holes on either a cutting board/high density fibreboard work well.  I looked closely at those OEM diaphragms and it appears as though the holes have been fused around the cut edges after cutting.  I was struggling getting the small holes for the pegs punched adjacent to the button/pintle pump area, as the material is very tough.  I heated up a small nail in a torch until it were glowing.  Melted perfect holes.  I imagine a soldering pencil would work as well.

Great info.  Good to see you here too.8)
-Aaron

For older saws:
Tune the H side so that it 4-strokes (burbles) at WOT unloaded and just cleans up when under load.
When you lift cutting load, the saw should immediately revert to 4-stroking.  Fine tune the transition point for the wood you're cutting.

 

Related Topics

  Subject / Started by Replies Last post
8 Replies
607 Views
Last post September 15, 2011, 08:02:28 pm
by Modifiedmark
1 Replies
388 Views
Last post November 27, 2011, 02:52:55 am
by Roanoker494
2 Replies
308 Views
Last post June 04, 2012, 02:42:51 pm
by rms61moparman
1 Replies
251 Views
Last post September 11, 2012, 10:24:23 am
by Cut4fun
3 Replies
243 Views
Last post September 05, 2013, 09:23:16 am
by jcsmith
Poulan 3800

Started by Cut4fun . « 1 2 3 » Poulan

24 Replies
652 Views
Last post May 10, 2018, 08:13:13 pm
by Eccentric
1 Replies
205 Views
Last post October 19, 2015, 03:03:17 pm
by Cut4fun .
3 Replies
199 Views
Last post July 20, 2016, 07:46:37 am
by leec
3 Replies
270 Views
Last post February 21, 2017, 07:52:38 am
by mowertech
0 Replies
61 Views
Last post May 01, 2020, 06:52:38 pm
by Cut4fun .