Author Topic: Poulan PP4218a wont run right  (Read 452 times)

0 Members and 3 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Poulan PP4218a wont run right
« on: January 09, 2014, 12:29:46 am »
I agree with fossil here.   I have found when the high and low needles are set they are usually pretty close to one another.   You might try and kit the carb or just get another one.   I can not imagine a new carb would cost very much.
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
17 Replies
1194 Views
Last post March 08, 2013, 04:08:19 pm
by brokenbudget
5 Replies
819 Views
Last post December 06, 2013, 07:42:56 pm
by Al Smith
80 Replies
4802 Views
Last post February 13, 2014, 02:37:33 pm
by mastercraftka
MS360 Pro wont start

Started by ears54 « 1 2 » Stihl

10 Replies
1358 Views
Last post August 16, 2015, 03:37:13 pm
by Cut4fun .
2 Replies
494 Views
Last post September 12, 2015, 09:44:05 pm
by jrdplowing
36 Replies
3148 Views
Last post February 11, 2016, 11:17:11 am
by 3000 FPS
2 Replies
619 Views
Last post December 30, 2015, 03:58:15 pm
by Cat-Face Timber
11 Replies
3714 Views
Last post June 05, 2017, 02:48:32 pm
by 3000 FPS
0 Replies
240 Views
Last post March 26, 2018, 03:35:00 pm
by dano
2 Replies
462 Views
Last post August 21, 2018, 01:22:59 pm
by trevor-t