Author Topic: Poulan 330 3450  (Read 20253 times)

0 Members and 75 Guests are viewing this topic.

Offline Eccentric

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 2117
  • Karma: 217
  • Magnesium and Iron.
  • Location: Northwestern Wyoming

  • Total Badges: 37
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary Fifth year Anniversary
Re: Poulan pro 330 and poulan 3450
« Reply #60 on: March 01, 2013, 06:10:49 pm »
I am wanting to run a 16'' 3/8 .050 K041 bar on my 330 and have had no luck finding one...can anybody have a good one to let go or can anyone provide a link on this wonderful internet where to get one. I have had no luck.

John just recently there were a few new 3/8-.050G K041 bars on feebay.  Gotta be careful that you don't buy a 3/8LP bar however.   Many 16-20" K041/A041 bars intended for WildThing type saws are LP.

You can also use a K095 ('small Husky') bar if you modify it a bit.  Just have to oblong the adjuster holes a tad (towards the bar rail) and slot a passage from the groove to the adjuster holes (as K041 saws oil through the adjuster holes).  Did that with a Husqvarna branded .325-.058G Oregon Power Match bar for my PP330.  Used a dremel with a reinforced cutoff wheel to slot down from the groove into the adjuster holes.

Oils fine.  Had to file the stud slot just a hair as well as it was TIGHT on the studs.  Also have to 'aim' the tensioner peg so that it goes into the adjuster hole as the peg 'sags' down a bit when there isn't a bar on the saw.  A little prod with the screwdriver was all it took.


 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1040 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
4079 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
16 Replies
2740 Views
Last post April 11, 2014, 07:03:51 am
by Tractorsaw1
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
3161 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
898 Views
Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
120 Replies
5378 Views
Last post October 07, 2023, 08:09:15 am
by Cut4fun
16 Replies
969 Views
Last post May 17, 2015, 10:00:49 am
by Cut4fun
2 Replies
594 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
8 Replies
785 Views
Last post June 05, 2015, 09:52:30 am
by Cut4fun .
2 Replies
444 Views
Last post February 28, 2018, 01:25:07 pm
by Cut4fun .