Author Topic: Poulan 330 3450  (Read 20211 times)

0 Members and 12 Guests are viewing this topic.

Offline 3000 FPS

  • Moderator
  • Nitro Hotsaw
  • *******
  • Posts: 4706
  • Karma: 320
  • Location: Carpenter, Wyoming

  • Total Badges: 43
    Badges: (View All)
    Tenth year Anniversary Nineth year Anniversary Level 7 Eighth year Anniversary Seventh year Anniversary Sixth year Anniversary
Re: Poulan 330 3450
« Reply #210 on: March 04, 2015, 11:31:30 am »
The worm gear requires a puller that threads on to the worm gear itself and then pulled off.   There is a part number for it but do not know where it is right now.

The way I remove the flywheel..    Take the nut and washer off.   Put the nut back on until it is flush with the end of the crank.
I then took a bolt the size of the nut and cut it off so that it was short enouph to sit on top of the nut and the end of the crank shaft.   I use that to hammer on so I do not mess up the threads of the crank.
I then put a screw driver under the flywheel and apply a little pressure and start tapping the end of the crank with just a medium blow from a hammer.   You may have to put the cut off bolt back into place, because  it will fall off but take your time and the flywheel will all of a sudden brake loose.   You will know because the screw driver will move.   
PP 505, 475, 445.

 

Related Topics

  Subject / Started by Replies Last post
3 Replies
1038 Views
Last post February 03, 2013, 06:33:10 pm
by 660magnum
Poulan 3450 60cc

Started by Cut4fun . « 1 2 ... 6 7 » Poulan

66 Replies
4061 Views
Last post February 08, 2018, 07:01:11 pm
by 3000 FPS
16 Replies
2736 Views
Last post April 11, 2014, 07:03:51 am
by Tractorsaw1
Poulan 3450 Carb issues

Started by rockfishon « 1 2 ... 7 8 » Poulan

77 Replies
3148 Views
Last post August 27, 2015, 07:55:47 pm
by Eccentric
5 Replies
898 Views
Last post October 23, 2014, 06:53:51 pm
by Cut4fun .
120 Replies
5363 Views
Last post October 07, 2023, 08:09:15 am
by Cut4fun
16 Replies
968 Views
Last post May 17, 2015, 10:00:49 am
by Cut4fun
2 Replies
594 Views
Last post March 20, 2015, 10:16:41 pm
by 3000 FPS
8 Replies
784 Views
Last post June 05, 2015, 09:52:30 am
by Cut4fun .
2 Replies
444 Views
Last post February 28, 2018, 01:25:07 pm
by Cut4fun .