Author Topic: Poulan 415  (Read 3700 times)

0 Members and 0 Guests are viewing this topic.

Offline Cut4fun .

  • Administrator
  • Nitro Hotsaw
  • *******
  • Posts: 21877
  • Karma: 522
  • OHIO REDNECK Saw Repair Getter Done
    • Redneck Chainsaw Repair
Re: Poulan 415
« Reply #40 on: February 01, 2016, 12:40:14 pm »
please give me pointers to fine tune it. It will run and idle for about two minutes by itself. Starts right back up. Does the impulse line need check valves etc.

no checks.

did you say you put a new carb rebuild kit in it?
I did rebuild the carb but may need to go back in and set the metering height to flush with top of metering deck. I set it to flush with carburetor top

Sent from my LG-D800 using Tapatalk



I dont remember the right setting off hand. Do you?
You need me to check my book or a carb I have off?
REDNECK Saw Repair Getter Done

 

Related Topics

  Subject / Started by Replies Last post
Poulan 365

Started by Cut4fun « 1 2 ... 16 17 » Poulan

169 Replies
4997 Views
Last post January 31, 2018, 07:59:31 pm
by stubnail67
Poulan 295 Porting

Started by Dh1984 « 1 2 » Poulan

11 Replies
1406 Views
Last post May 20, 2011, 08:55:11 am
by Dh1984
3 Replies
371 Views
Last post June 11, 2011, 05:25:29 pm
by Cut4fun
Poulan pro 236

Started by Cut4fun . « 1 2 3 4 5 » Poulan

48 Replies
1611 Views
Last post December 04, 2015, 10:59:11 am
by Cut4fun .
Poulan 1800

Started by Cut4fun . « 1 2 » Poulan

12 Replies
1182 Views
Last post December 23, 2013, 06:06:19 pm
by bustedknuckles
222 Replies
6602 Views
Last post June 29, 2020, 07:46:24 pm
by Cut4fun .
4 Replies
537 Views
Last post November 23, 2012, 12:28:15 am
by Andyshine77
23 Replies
1188 Views
Last post November 02, 2015, 04:36:50 pm
by Cut4fun .
2 Replies
214 Views
Last post May 21, 2017, 08:59:45 pm
by Cut4fun .
8 Replies
210 Views
Last post December 31, 2018, 09:04:53 am
by Cut4fun .