Chainsaw Repair

You can't weld up that plastic like you can magnesium. 

That 272 cover I just bought has a crack in it looking at pic.

 Going to see if it is durable enough as is when it gets here after trimming up.

I posted a pic above of the 1st one I made from a husky cover to compare.

I will look at the one on hand from the 268 when I go out to clean on that  very echo. I think it is just a small hole where the brake band ran down through. Nothing to really weld up IMO, will know soon with a pic. 

I suppose by the time you pay for shipping you could buy one of the plastic ones.

Yep     I'm not going to worry about the hole which is a little  bigger then I was thinking.

I am still looking for a crank seal on the Clutch side of my 475.   I found the one for the flywheel side and ordered and recieved it but still have not found one for the clutch side.   I was comparing the Jonsered 2077 and 2083 but do not know if the case is the same.  I also looked at the Husky 372 but once again I am not sure if the case is the same.   Have any of you tried a seal from one of these other saws for the clutch side and have it work ok, or know of another alternative.   

Roger

That part number 503422201 I have tried to find and so far no luck.   There are plenty of places that say they have them and when you go to order it, they will finaly get back and say no we don't.  If you have a source that you know is good I could sure use it.